Nanoactive filter Attention

1. Nano-flame-retardant filter according to the actual needs, to regularly clean the dust, dust in the dust collection equipment when cleaning, just when stopping the work of the blower and dust collection cloth, open the sealed gold door, soot falls into the tube, box or indirectly on the conveyor belt.
In order to better ensure that the dust collection equipment is in the best working condition, it should be as close as possible to the origin of the smoke and dust, generally better from 1.5 to 2.0 m, connect the pipelines as short as possible, and minimize the bends to avoid increasing resistance.
3. Nano flame retardant filter dust collector is an important spare part to ensure that the autonomous nano flame retardant filter generator unit is in all normal working conditions, the use department should according to the external size of the processing parts characteristics of smoke and dust, according to the basic principles of passage, proximity, shunt, seal, Design dust collector, make perfect dust collector.
9.JPG
4. The cylinder filter control box cover cannot be opened at the discretion during operation, if it is necessary to adjust the ash removal time or check the power circuit, the power switch should be turned off after operation.
5, Nano-flame-retardant filter according to the characteristics of the smoke dust and the size of the storage tank, must regularly remove dust, dust removal is carried out by the software process of the controller's electric motor to regularly run the arterial valve, so that the air compression in the package (0.5-0.7 MPa) from the spray hole (called primary wind) According to the venturi tube caused by the frequency of the ambient gas flare (called the secondary wind) into the filter bag, so that the bag expands considerably in the blink of an eye, and with the reverse effect of the gas the smoke trembles, so that the purpose of dust removal.